acl-mac-show
Displays information about the ACLs using MAC addresses as a parameter.
Syntax acl-mac-show
|
name name-string |
Specifies the name of the ACL. |
|
id |
Specifies the ID generated by ONVL. |
|
action permit|deny |
Specifies the permission of the ACL to be either permit or deny. |
|
src-mac mac-address |
Specifies the source MAC address of the ACL. The value can be any to match all MAC addresses |
|
src-mac-mask mac-address |
Specifies the source MAC address mask. |
|
dst-mac mac-address |
Specifies the destination MAC address of the ACL. The value can be any to match all MAC addresses. |
|
dst-mac-mask mac-address |
Specifies the destination MAC address mask. |
|
ether-type ipv4|arp|wake|rarp|vlan|ipv6|mpls-uni|mpls-multi|jumbo|aoe|dot1X|lldp|lacp|ecp|macsec|ptp|fcoe|fcoe-init||qinq-old |
Specifies the EtherType value. |
|
vnet vnet-name |
Specify the name of the VNET. |
|
bd bridge-domain name |
Specify the bridge domain name assigned to the ACL. |
|
vlan vlan-id |
Specifies the VLAN identifier, a value between 0-4095. |
|
scope local|fabric |
Specifies the scope of the ACL. |
|
port port-number |
Specifies the switch port number. |
Defaults None
Access CLI
History
|
Version 1.2.1 |
Command introduced. |
|
Version 2.4.1 |
The parameter, vnet, added. |
|
Version 2.5.2 |
The parameter, cluster,deprecated. |
Usage MAC access control lists (ACLs) filter network traffic. This command displays a list of MAC ACLs.
Examples This example shows how to list all MAC ACLs.
CLI network-admin@switch > acl-mac-show
name id action src dst type vlan scope port
-------- --------------- ------ ----------------- -------------------- ----- ----- ----
MyMacACl 54147812341841957 deny e0:f8:47:14:3c:2e ff:ff:ff:ff:ff:ffipv4 0 local 0