mirror-show
This command is used to display information about port mirroring on the switch.
Syntax mirror-show
|
name name-string |
Specifies a name for the mirror configuration. |
|
id |
Specifies the mirror ID assigned by nvOS. |
|
direction ingress|egress|bidirection |
Specifies a direction for the mirrored traffic. |
|
out-port port-list |
Specifies the port for outgoing traffic. |
|
out-trunk trunk name |
Specifies the name of the outgoing trunk configuration. |
|
loopback-port loopback-port-number |
Specifies the loopback port for mirrored traffic. |
|
in-port port-list |
Specifies the port for incoming traffic. |
|
filtering port| |
Specifies the filter type for the configuration. |
|
enable|disable |
Enable or disable the configuration. |
|
other-egress-out allow|prevent |
Specifies if other outgoing traffic is allowed or prevented. |
|
span-encap none|over-ip|over-vlan |
Specify the mirror span type. The default type is none. |
|
span-local-ip ip-address |
Specify the local IPv4 address for the mirror span. |
|
span-remote-ip ip-address |
Specify the remote IPv4 address fpr the mirror span. |
|
span-src-mac mac-address |
Specify the source MAC address for the mirror span. |
|
span-dst-mac mac-address |
Specify the destination MAC address for the mirror span. |
|
span-tagging-vlan vlan-id |
Specify the mirror span VLAN tagging ID. The default value is none. |
|
span-tos integer |
Specify the mirror span ToS from 0 to 255. The default value is 0. |
|
nvie-mirror|no-nvie-mirror |
Specify to mark this mirroring as an NVIE mirror and mirror traffic to NVIE VM. |
Defaults None.
Access CLI
History
|
Version 1.2 |
Command introduced. |
|
Version 2.0 |
Command changed to mirror-show. |
|
Version 2.4 |
The parameter, span-, introduced. |
|
Version 2.6.2 |
The parameter, nvie-mirror, added. |
Usage Use this command to display port mirroring information.
Examples To display information about port mirroring, use the following command:
CLI (network-admin@pleiades25) > mirror-show
switch: pleiades25
mirroring: disable