vport-settings-show
Netvisor collects and stores vPort information on a disk on the switch at specific intervals. This command is used to display the vPort settings.
Syntax vport-settings-show
Defaults See individual parameters.
Access CLI
History
|
Version 2.2 |
Command introduced. |
|
Version 6.0.0 |
The parameters, excess-mac-move-protection-enable, excess-mac-move-queue-protect,excess-mac-move-queue-state, excess-ip-move-protection-enable, excess-ip-move-queue-protect, and excess-ip-move-queue-state added. |
Usage Use the command to display vPort settings for collecting vPort information.
Examples To display vPort settings, use the following syntax:
CLI (network-admin@switch1) > vport-settings-show format all
switch: switch1
vport-disk-space: 500M
stats-max-memory: 50M
stats-log-enable: yes
stats-log-interval: 1m
stats-log-disk-space: 50M
system-stats-max-memory: 50M
system-stats-log-enable: yes
system-stats-log-interval: 1m
system-stats-log-disk-space: 50M
loop-prevent: enabled
excess-mac-move-protection-enable: yes
excess-mac-move-queue-protect: yes
excess-mac-move-queue-state: active
excess-ip-move-protection-enable: yes
excess-ip-move-queue-protect: yes
excess-ip-move-queue-state: active