vrouter-routes-multicast-show
This command allows you to display information about multicast routes on a vRouter configured on the switch.
Syntax vrouter-routes-multicast-show
|
vrouter-name name-string |
Specifies the vRouter name. |
|
source ip-address |
Specifies the source IP address. |
|
group ip-address |
Specifies the IP address of the group. |
|
proto rip|connected|static|ospf|bgp|missing| |
Specifies the protocol used by the routes. |
|
input input-string |
Specifies the input interface for incoming routes. |
|
iVifI iVifI-number |
Specifies the input index for on a virtual interface (VNIC). |
|
output output-string |
Specifies the output interface for an outgoing routes. |
|
oVifI oVifI-number |
Specifies the output index for a virtual interface (VNIC). |
|
ttl ttl-number |
Specifies the time-to-live (TTL) value. |
|
uptime uptime-string |
Specifies the uptime for the route. |
Defaults None
Access CLI
History Command introduced in nvOS Version 1.2.1
Usage You can display information about the multicast routes on a vRouter.
Examples To display multicast route information, use the following command:
vrouter-routes-multicast-show layout vertical
vrouter-name: vr1
source: 10.13.25.200
group: 232.1.1.1
proto: vr1.eth0
iVifI: 2
output: vr1.eth1
oVifI: 3
ttl: 1
uptime: 00:00:01