Guidelines to Remember While Configuring sFlow



There are some  guidelines to consider while configuring the sFlow monitoring feature:


  • The sFlow monitoring system  is a local scoped feature.
  • You can configure the sFlow sample rate between the range 256-16000, by default the sample rate is set to 4096. To disable the sFlow sampling, configure the sample rate to zero (0) .
  • The sFlow Agent ID is  typically a switch management IP  address and indicates the originator or sample frames provider.
  • The sFlow monitoring system supports only IPv4 sampling.
  • The sFlow sample type can be either raw or cooked mode, and the default mode is raw
  • By default, the counter-polling-interval is 2 seconds and the available range is 1-120 seconds. However, to disable the counter sampling, you can set the interval to zero (0).
  • The CLI parameter, sample-pkt-cnt is the actual sampled packets from the sFlow Agent.
  • The sFlow Collector configuration requires the Collector IP address and Collector port list.
  • The sFlow Collector configuration can be local or fabric scoped feature.
  • You can configure multiple collector configurations, however, the first or the latest available Collector is selected for sending the sampled packets.
  • The egress sflow samples do not make modification to the packets in the egress pipeline(for example, VLAN translation, VXLAN header encap). 


north
    keyboard_arrow_up
    keyboard_arrow_down
    description
    print
    feedback
    support
    business
    rss_feed
    south