vrouter-ospf6-neighbor-show
This command is used to display OSPF6 neighbors for a vRouter configured for OSPF6.
Syntax vrouter-ospf6-neighbor-show
|
vrouter-name name-string |
Name of the vRouter. |
|
neighbor-rid ip-address |
The router ID IP address of the OSPF neighbor |
|
pri pri-number |
The priority number. |
|
state state-string |
The current state of the OSPF neighbor. |
|
dead-time dead-time |
The dead-time. Dead-time is the interval of time that the vRouter waits before declaring a neighbor is down. |
|
duration duration-string |
The duration in hh:mm:ss. |
|
interface interface-string |
The interface on the vRouter. |
Defaults None.
Access CLI
History
|
Version 2.3.1 |
Command introduced. |
Usage Each fabric, cluster, standalone switch, or virtual network (vNET) can provide its tenants with a virtual router (vRouter) service that forwards traffic between networks, and implements Layer 3 protocols. This command displays OSPF6 information for an existing Router service.
Examples To display information about all OSPF6 neighbors on the network, use the following command:
CLI (network-admin@switch) > vrouter-ospf6-neighbor-show
vrouter-name neighbor-rid pri state dead-time duration address interface vlan l3-port vrf
------------ ------------ --- -------- --------- -------- ------------- ------------- ---- ------- ---
sw55 10.255.56.56 1 Full/BDR 00:00:33 01:51:54 2555:5657::1 eth0.4000[DR] 4000
sw55 10.255.54.54 1 Full/BDR 00:00:32 01:44:58 2595:0:55::54 eth0.4092[DR] 11