port-breakout-config-modify
This command is used to configure the port breakout mode.
Syntax port-breakout-config-modify
|
port port-list |
Specifies the port number or list of ports. |
|
breakout sys-default|400g-1x|100g-4x|100g-2x |
Specify the port breakout mode: System-default: each bezel port is 400G/PAM4 for the first two entries, then 100G/PAM4 for third entry, and 100G/NRZ for fourth entry. |
Defaults None
Access CLI
History
|
Version 7.0.1 |
Command introduced. |
Usage Use this command to modify the port breakout configuration.
Information This command is applicable only on Z9432F-ON platform in NetVisor version 7.0.1.
Examples To set the port speed, use the following command:
CLI (network-admin@switch) > port-config-modify port 5 speed 100g