port-breakout-config-show
This command is used to display the port breakout configuration.
Syntax port-breakout-config-show
|
port port-list |
The port number or list of ports. |
|
breakout sys-default|400g-1x|100g-4x|100g-2x |
Specify the port breakout mode: System-default: each bezel port is 400G/PAM4 for the first two entries, then 100G/PAM4 for third entry, and 100G/NRZ for fourth entry. |
|
status sys-default|400g-1x|100g-4x|100g-2x |
The port breakout mode status. |
|
present|no-present |
Indicates if a transceiver is present or not. |
|
type unknown|sfp|qsfp28|qsfp56-dd|sfp-dd |
The transceiver type. |
|
match unknown|match|not-match |
Indicates whether configured mode is a match for the installed transceiver. |
Defaults None
Access CLI
History
|
Version 7.0.1 |
Command introduced. |
Usage Use this command to display the port breakout configuration.
Information This command is applicable only on Z9432F-ON platform in NetVisor version 7.0.1.
Examples To display the port breakout mode configuration, use following command:
CLI (network-admin@switch) > port-breakout-config-show port 5
switch port breakout present type match
------ ---- -------- ------- ------ -----
switch 5 100g-2x yes qsfp28 match