stp-port-event-show
This command is used to display information about port events on the switch.
Syntax stp-port-event-show
|
time date/time: yyyy-mm-ddThh:mm:ss |
A specific time for an event. |
|
start-time date/time: yyyy-mm-ddThh:mm:ss |
The time that the event began. |
|
end-time date/time: yyyy-mm-ddThh:mm:ss |
The time that the event ended. |
|
duration duration: #d#h#m#s |
The duration in days, hours, minutes, and seconds. |
|
interval duration: #d#h#m#s |
The interval between the events. |
|
since-start |
Specifies if the event is requested since the start time. |
|
older-than duration: #d#h#m#s |
Specifies if the event is older than the requested duration. |
|
within-last duration: #d#h#m#s |
Specifies if the event is within the last requested duration. |
|
port port-number |
The port number of the event. |
|
vlan vlan-list |
The VLAN list for the event. |
|
instance instance-number |
The instance for the STP events collection. |
|
count count-number |
The number of events. |
|
initial-state Disabled|Blocking|Listening|Learning|Forwarding |
The initial state of the event. |
|
other-state Disabled|Blocking|Listening|Learning|Forwarding |
Specifies if the event had other states. |
|
final-state Disabled|Blocking|Listening|Learning|Forwarding |
The final state of the event. |
Defaults None
Access CLI
History
|
Version 2.0 |
Command introduced. |
|
Version 2.4.1 |
The parameter instance added. |
Usage Use this command to display port event information for STP.
Examples To display STP port events, use the following command:
CLI (network-admin@switch) > stp-port-event-show