stp-show
This command is used to display information about Spanning Tree Protocol (STP) state.
Syntax stp-show
Defaults None.
Access CLI
History
|
Version 1.2 |
Command introduced. |
|
Version 2.4 |
The parameters mst-config, and mst-max-hops added. |
|
Version 3.0.0 |
The parameter root-guard-wait-time added. |
|
Version 6.0.1 |
The parameter mst-config-revision, mst-config-name,mst-config-digest, mst-digest-mismatch-on-ports, mst-digest-mismatch-on-peer-ports, mst-config-id-mismatch-on-ports, mst-config-id-mismatch-on-peer-ports, mst-revision-mismatch-on-ports, mst-revision-mismatch-on-peer-ports added. |
Usage STP is a standard inter-switch protocol is used to ensure that an ad hoc network topology is loop-free at Layer 2, on a per VLAN basis. If your network connections form loops, and STP is disabled, packets recirculate between the switches, and causes a decrease in network performance. If you are certain that your network is loop-free, you do not need to enable STP. Use this command to enable or disable STP on the network.
Examples To display STP information, use the following command:
CLI (network-admin@switch)1 > stp-show
switch: switch1
enable: yes
stp-mode: mstp
bpdus-bridge-ports: yes
bridge-id: 66:0e:94:93:05:f1
hello-time: 2
forwarding-delay: 15
max-age: 20
mst-max-hops: 20
mst-config-name: Pluribus
mst-config-revision: 0
mst-config-digest: 9ae933ff602798b5e8b9a9c575f5c642
mst-digest-mismatch-on-ports: none
mst-digest-mismatch-on-peer-ports: none
mst-config-id-mismatch-on-ports: none
mst-config-id-mismatch-on-peer-ports: none
mst-revision-mismatch-on-ports: none
mst-revision-mismatch-on-peer-ports: none
root-guard-wait-time: 20