Configure Date and Time
Option 2: Configure Date / Time
A new screen is launched and using the available Options you set Date and Time or adjust the Time Zone by selecting Option 1 and Option 2.
Note: Stop NetVisor UNUM to update Date, Time and Time Zone. If NetVisor UNUM is running, select Option 4 from the Installation Setup menu before attempting to change or configure Date, Time or Time Zone. After making your changes, restart NetVisor UNUM using Option 3 from the Installation Setup menu.
To update or change the NTP server setting use Option 3.
To perform an NTP Status Check use Option 4.
Option 0 returns you to the main menu.
NetVisor UNUM Date & Time
NetVisor UNUM Date & Time - Stop NetVisor UNUM Message
NetVisor UNUM Select Date & Time
NetVisor UNUM Select Time Zone
As described above press any key to continue and select the applicable geographical area.
NetVisor UNUM Select Geographical Area
NetVisor UNUM Select City or Region
After selecting the applicable city of region Click <Ok> to return to the previous screen and select Option 0 to return to the main screen.
NetVisor UNUM Time and Date Completed
The date, time and time zone settings are updated.
You press any key to continue and a full summary of the date, time and time zone entries are displayed along with additional information pertaining to daylight savings time. NTP time servers start and are adjusted accordingly.
NetVisor UNUM Date, Time, Time Zone Settings Summary
To change or update the NTP Servers select Option 3.
Enter at least two NTP Server addresses. Use a comma between each value.
Note: When entering more than one NTP server in the NetVisor UNUM_setup, do not include a space after the comma-separated list. For example, enter in the format:
10.135.2.13,10.20.4.1 or 0.north-america.pool.ntp.org,1.north-america.pool.ntp
NetVisor UNUM Configure / Update NTP Servers
NetVisor UNUM restarts the NTP service and makes the required adjustments.
NetVisor UNUM Configure / Update NTP Servers
Note: When changing NTP Servers, please allow sufficient time for the servers to re-synchronize. NetVisor UNUM may return an " error " message after successfully updating the NTP servers and immediately running the NTP status check. However, after a while, depending on network connectivity and NTP server load, NetVisor UNUM eventually returns a "success" message after the NTP server has properly synchronized.
To perform an NTP status check select Option 4.
NetVisor UNUM performs a check to ensure the NTP servers respond in a timely manner and reports a success message accordingly.
NetVisor UNUM Configure / Update NTP Servers - Status Check
When the Date, Time, Timezone and NTP Server configuration is complete, select Option 0 to return to the setup menu.
NetVisor UNUM Options Menu