Option 3 & Option 4: - Start / Stop NetVisor UNUM


Start NetVisor UNUM


From time to time, you may need to stop or start the NetVisor UNUM service when configuring specific settings or when initially configuring NetVisor UNUM. You start the NetVisor UNUM services by selecting Option 3.


The Installation Setup screen displays the list of starting services.


NetVisor UNUM - Start Services



Note: The Eth2 Warning message alerts you to configure this interface if you use it for Inband management.


If you have stopped services on other VMs for NetVisor UNUM, the Installation Setup wizard prompts you to start the services on other VMs.


Start Other VM Services


After all services are started point your browser to http://<your VM ip>/ to display the NetVisor UNUM interface.


Stop NetVisor UNUM


If NetVisor UNUM is running and before attempting any configuration changes you must stop the services by selecting Option 4.


The Installation Setup screen displays the list of stopping services.


NetVisor UNUM - Stop Services


If you have VMs configured as clusters for NetVisor UNUM, the installation prompts you to stop the services on other VMs.


You must use the right SSH username and password, and this information should be the same for all nodes in the cluster.


NetVisor UNUM - Prompt to Stop Other VM Services



Note: In the event of a server / VM reload, re-run the ‘UNUM_setup.sh’ script again first stopping services and then re-starting the services using Option 4 and Option 3.

north
    keyboard_arrow_up
    keyboard_arrow_down
    description
    print
    feedback
    support
    business
    rss_feed
    south