Configuring High Availability This chapter provides information for understanding and using the Pluribus Networks Netvisor OONEne command line interface (CLI) on a Netvisor ONE switch to configure High Availability. Understanding the High Availability Feature in Netvisor ONE Configuring a Cluster Understanding Link Aggregation Configuring a vLAG Understanding the Link Aggregation Control Protocol (LACP) Modifying LACP Mode and Parameters on an Existing vLAG Configuration Understanding Switch Clusters Configuring the Cluster Slave Switch Bring-up Process About the Spanning Tree Protocol (STP) in Cluster Mode Configuring Active-Active vLAGs: a Step-by-Step Example About Split Brain Understanding the vLAG Forwarding Rule About Layer 3 Hardware Forwarding in a Cluster Configuring Asymmetric Routing over vLAGs Understanding vLAGs About Symmetric Routing over vLAGs Understanding Virtual Router Redundancy Protocol (VRRP) Configuring Active-Active vLAG Forwarding with Loopback Recirculation About Cluster Active-Active Routing for IPv6 Addresses Configuring Virtual Router Redundancy Protocol Guidelines and Limitations Troubleshooting High Availability Configuring Static Trunking for Link Aggregation Supported Releases Configuring Active-Standby Link Failover on Management Interfaces Related Documentation Configuring Link Aggregation Control Protocol (LACP)
