(CLI network-admin@Spine1)>switch-setup-show format in-band-ip,in-band-ip6,loopback-ip,loopback-ip6, layout horizontal
 
in-band-ip in-band-ip6 loopback-ip loopback-ip6
------------ ----------- ----------- ------------
150.1.1.1/24 2001::1/96 12.1.1.1 1212::1
150.1.1.2/24 2001::2/96 12.1.1.2 1212::2
 
After configuring the loopback address, you can SSH to the switch over the management, in-band, or loopback interface using the following syntax:
ssh network-admin@<mgmt/inband/loopback ip-address>
 
Then from CLI, execute the shell command to access the switch shell:
network-admin@Spine1:~$