Start / Stop UNUM
Option 3 & Option 4: - Start / Stop UNUM
Start UNUM
From time to time, you may need to stop or start the UNUM service when configuring specific settings or when initially configuring UNUM. You start the UNUM services by selecting Option 3.
The Installation Setup screen displays the list of starting services.
UNUM - Start Services
Note: The Eth2 Warning message alerts you to configure this interface if you use it for Inband management.
If you have stopped services on other VMs for UNUM, the Installation Setup wizard prompts you to start the services on other VMs.
Start Other VM Services
After all services are started point your browser to http://<your VM ip>/ to display the UNUM interface.
Stop UNUM
If UNUM is running and before attempting any configuration changes you must stop the services by selecting Option 4.
The Installation Setup screen displays the list of stopping services.
UNUM - Stop Services
If you have VMs configured as clusters for UNUM, the installation prompts you to stop the services on other VMs.
You must use the right SSH username and password, and this information should be the same for all nodes in the cluster.
UNUM - Prompt to Stop Other VM Services
Note: In the event of a server / VM reload, re-run the ‘UNUM_setup.sh’ script again first stopping services and then re-starting the services using Option 4 and Option 3.