Setting the Date and Time


To set the date and time on the switch, modify the switch configuration using the switch-setup-modify command. To change the date and time to August 05, 2019, 04:30:00, use the following syntax:


CLI (network-admin@Leaf1) > switch-setup-modify date 2019-08-05 T04:30:00


Display the configured setting using the switch-setup-show command:


CLI (network-admin@Leaf1) > switch-setup-show


switch-name:               Leaf1

mgmt-ip:                   10.80.241.235/25

mgmt-ip-assignment:        static

mgmt-ip6:                  2001:aaaa::10:80:241:235/112

mgmt-ip6-assignment:       static

mgmt-link-state:           up

mgmt-link-speed:           1g

mgmt-secondary-link-state: down

mgmt-secondary-link-speed: disable

in-band-ip:                192.168.241.235/24

in-band-ip6:               fe80::640e:94ff:fe3f:fafc/64

in-band-ip6-assign:        autoconf

gateway-ip:                10.80.241.129

gateway-ip6:               2001:aaaa::10:80:241:ffff

dns-ip:                    10.80.241.94

dns-secondary-ip:          10.80.241.98

domain-name:               pluribusnetworks.com

ntp-server:                10.80.241.94

timezone:                  America/Los_Angeles

date:                      2019-09-19,04:30:00

hostid:                    285212991

location-id:               2

analytics-store:           default

enable-host-ports:         yes

banner:                    * S2L CONVERSION SETUP ERIC05 *

mgmt-lag:                  enable

mgmt-lacp-mode:            off


The analytics-store parameter refers to the storage location for analytics which in this case is the hard drive on the switch. Netvisor ONE does not support external hard drives.